Skip to content

Publications C22.2 NO. 29-15

Sorry, no image available for C22.2 NO. 29-15

C22.2 NO. 29-15 - Panelboards and enclosed panelboards

Publication Year:

  • 2015

Total Pages:

83

Publisher:

  • CSA
Update #1 to this standard is available.

To download any updates and/or register for email notification of future updates click here

Preface

This is the sixth edition of C22.2 No. 29, Panelboards and enclosed panelboards, one of a series of Standards issued by CSA Group under Part II of the Canadian Electrical Code. It supersedes the previous editions published in 2011, 1989, 1983, 1955, and 1936.

In addition to incorporating minor edits and corrections to the previous edition, this new edition includes the requirements for:

a) determining the accessibility of live parts by use of a finger probe;

b) the integration of transfer switch equipment within a panelboard;

c) clarification of neutral assembly requirements; and

d) clarification of ampacity termination temperature markings.

For general information on the Standards of the Canadian Electrical Code, Part II, see the Preface of CAN/CSA-C22.2 No. 0, General Requirements - Canadian Electrical Code, Part II.

Scope

1.1
This Standard applies to panelboards and enclosed panelboards, rated 600 V and less, for use in nonhazardous locations in accordance with the Canadian Electrical Code, Part I, to provide overcurrent protection for a number of circuits.

1.2
Clauses 1 to 6 apply to panelboards and enclosed panelboards of other than the service entrance type and apply, unless otherwise noted, to the panelboards covered by Clauses 8 and 9 as follows:

a) Clause 8 - panelboards for service entrance use; and

b) Clause 9 - custom-built panelboard assemblies.

1.3
This Standard covers the construction of the synthetic fuses to be used in the simulated load cycle test on fusible panelboards. (See Clause 10.)

1.4
In this Standard, "shall" is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; "should" is used to express a recommendation or that which is advised but not required; and "may" is used to express an option or that which is permissible within the limits of the standard.

Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.

Notes to tables and figures are considered part of the table or figure and may be written as requirements.

Annexes are designated normative (mandatory) or informative (nonmandatory) to define their application.

Publication type

Print Page

Tell a Friend

GST REG No R119441681
QST REG No R1006017360