ASME has been defining piping safety since 1922. ASME B31.3 contains requirements for piping typically found in petroleum refineries; chemical, pharmaceutical, textile, paper, semiconductor, and cryogenic plants; and related processing plants and terminals. It covers materials and components, design, fabrication, assembly, erection, examination, inspection, and testing of piping. This Code applies to piping for all fluids including: (1) raw, intermediate, and finished chemicals; (2) petroleum products; (3) gas, steam, air and water; (4) fluidized solids; (5) refrigerants; and (6) cryogenic fluids. Also included is piping which interconnects pieces or stages within a packaged equipment assembly. Key changes to this revision include Category M fluid service definition revised, Revision to the equation for allowable stress range, Thermowell design, Use of cold spring, Impact testing of carbon steels, Installation of Weldolets, Preheat requirements, Heat treatment requirements, Qualification of examination personnel, Acceptance criteria for liquid penetrant an magnetic particle examination, Leak test for high pressure piping, and Alternative rules for evaluation of stress range, Appendix P. B31.3 is one of ASME's most popular codes, widely adopted by jurisdictions worldwide. It serves as a companion to ASME's B31.1 Code on Power Piping as well as to the other codes in ASME's B31 series. Together, they remain essential references for anyone engaged with piping. Careful application of these B31 codes will help users to comply with applicable regulations within their jurisdictions, while achieving the operational, cost and safety benefits to be gained from the many industry best-practices detailed within these volumes. Intended for manufacturers, users, constructors, designers, and others concerned with the design, fabrication, assembly, erection, examination, inspection, and testing of piping, plus all potential governing entities.
GST REG No R119441681
QST REG No R1006017360